ABTIS 1000 (M&C)
PET/PP bottle wall-thickness measurement system.
Questions? Call Us!
ph: +1 603 559 9700
Enhance laboratory testing efficiency and productivity.
Greater precision versus handheld hall-effect methods.
1 required day for typical admin level training.
N-IR based technology without the limitations of other manufacturers.
Data output compatible with most commercial SPC software packages.
In 2008, AVID customers in the PET packaging industry requested that AVID Corporation develop an automated bottle wall-thickness measurement system as an alternative to manual measurement techniques. Such techniques, such as hall effect micrometers, were simply unable to provide data quickly, efficiently, or with repeatability.
AVID Corporation is pleased to offer the ABTIS 1000, an offline wall-thickness measurement system for laboratory use. The ABTIS 1000 functions on the principle of near-infrared (N-IR) absorption of PET. By analyzing the amount of N-IR light absorbed by the plastic material, the ABTIS 1000 is capable of measuring the thickness of that material.
The system utilizes automated wall-scans at defined positions. This automatic measurement eliminates tedious and non-repeatable hand measurements. The option for automatic loading & unloading via a conveyor auto-feeder increases throughput and testing efficiency; the operator only loads the sample set of parts onto the conveyor. Measurement, data capture and part handling are all controlled by the ABTIS 1000.
During a circumferential (horizontal) test, the bottle is spun 360° while the system monitors thickness at specified heights. The resulting “bands” of thickness data are of use to those manufacturers monitoring thickness at defined locations around the package.
Programs can easily be narrowed to provide measurements at set angles, or to highlight min (“min-wall”), max and average thickness information for each band in the data stream, simplifying most general data analysis requirements.
Profile data can be used to illustrate material distribution throughout the package, or to demonstrate section distribution, in some cases replacing destructive and time-consuming “section-weight” tests.
Automated wall scanning at part specific defined heights and angles eliminates tedious and non-repeatable hand measurements. Measurement, data capture and part handling are all controlled by the ABTIS 1000.
ABTIS can also be run in a “min-wall” mode that will measure user-defined areas of the bottle sidewall and report the minimum, maximum and average wall-thickness of the entire bottle.
The ABTIS 1000 is available in both a manually loaded (1000M) and a automatic conveyor load (1000C) configuration.
The N-IR technology functions well for PET & PP materials. However, due to contaminants inherent in the processing PE packaging the ABTIS 1000 is not appropriate for measuring thickness of HDPE or LDPE packaging. Customers requiring a thickness system for these materials should consider the ABTIS-FENCER wall-thickness system.
PET/PP Bottle Wall Thickness
PET/PP Bottle 'Heel' Thickness
PET/PP Bottle Overall Height
PET/PP Bottle Base Clearance (from top of “push-up”)
Bottle Weight (with scale option)